Hettich Door Bend Adjustment Rod Fittings
- For straightening distorted furniture doors
- It can also be used as a precautionary measure to prevent doors from warping
- For door / front panel thicknesses from 16 mm
- Maximum door / front panel height 2600 mm
- Installing the fitting is simple and straightforward: a pair of threaded rods, one with a right-hand thread and one with a left-hand thread, are fed into a clamping sleeve
- The threaded rods are each additionally supported in a housing that slots into a 35 mm drilling where it is screwed into place
- Turning the clamping sleeve produces a tensile or compressive force that corrects door warping or bowing
- The housing, clamping sleeve, and threaded rods are covered to prevent damage to the wardrobe and laundry
- The adjustment fitting can also be used horizontally
- It is recommended that 2 vertical adjustment fittings be installed near the outer edge. On large, wide doors, 2 horizontal fittings can be used instead or in addition
- 2 adjustment fitting sets are required per door
